Geared DC Motors are widely used by electronics enthusiasts, makers, hobbyists to put motion into their projects. These are especially helpful for beginners who want to make a robot or even a project that has mechanical movement. However, many have difficulty soldering and are unable to actually connect the wires from the power source to the motor itself. Therefore, this leads to many using pre-built kits, which usually have less power(torque or rpm) as compared to their 'scratch' counterparts. I therefore designed these connector PCB's, which are meant to be soldered onto commonly available geared DC Motors in order to make connecting wires as simple as tightening a screw. The PCB's were fabricated from China and are low cost, thereby keeping the use of the motors economical yet easy.